[LinuxPPS] Re: ntpd and getaddrinfo errors

[raffaele messuti]

On Sep 25, 2006, at 4:52 PM, Udo van den Heuvel wrote:
>> so, how i can verify interrupts for port?
>
> DCD is the PPS signal from teh devcie, yes?
> If so one could use minicom to make sure one sees DCD flash on/off?
> (Folkert did this)


% stty -a -F /dev/ttyS1
speed 4800 baud; rows 0; columns 0;
intr = ^C; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;  
eol2 = <undef>; start = ^Q; stop = ^S; susp = ^Z;
rprnt = ^R; werase = ^W; lnext = ^V; flush = ^O; min = 1; time = 0;
-parenb -parodd cs8 hupcl -cstopb cread clocal -crtscts
                                         ^^^^^^
-ignbrk -brkint -ignpar -parmrk -inpck -istrip -inlcr -igncr icrnl  
ixon -ixoff -iuclc -ixany -imaxbel
opost -olcuc -ocrnl onlcr -onocr -onlret -ofill -ofdel nl0 cr0 tab0  
bs0 vt0 ff0
isig icanon iexten echo echoe echok -echonl -noflsh -xcase -tostop - 
echoprt echoctl echoke

moreover:
% cat /proc/tty/driver/serial
serinfo:1.0 driver revision:
0: uart:16550A port:000003F8 irq:4 tx:0 rx:0 RTS|DTR
1: uart:16550A port:000002F8 irq:3 tx:79 rx:13577 fe:166 brk:7

what else i can investigate?
bye ;)


--
<raffaele at atomotic.com> [0x39C336BC]