[LinuxPPS] debug output

[Rodolfo Giometti]

On Fri, Feb 23, 2007 at 02:12:49PM -0800, gnu not unix wrote:

> It still needs the ||, though. 

You are right, sorry! :)

> Here's the debug output, first the setserial then the ppstest:
> 
> SETTING UART_IER
> SETTING UART_IER AS 5
> FLAGS2 10000840
> serial_core: PPS source #0 "/dev/ttyS0" added to the system 
> SETTING UART_IER
> ENABLE UART_IER_MSI IRQ
> SETTING UART_IER AS d

Now it seems ok, doesn't it? The DCD irq is now enabled.

> pps_core: New message from PID 1278 (flags 0)
> pps_core: PPS_FIND_SRC: source -1
> pps_core: start sending reply to ID 1278...
> pps_core: ... reply sent (180)
> SETTING UART_IER
> ENABLE UART_IER_MSI IRQ
> SETTING UART_IER AS d
> pps_core: New message from PID 1278 (flags 0)
> pps_core: PPS_CREATE: source 0
> pps_core: start sending reply to ID 1278...
> pps_core: ... reply sent (180)

So, what about the "assert" events? Did you get them correctly?

Ciao,

Rodolfo

-- 

GNU/Linux Solutions                  e-mail:    giometti at enneenne.com
Linux Device Driver                             giometti at gnudd.com
Embedded Systems                     		giometti at linux.it
UNIX programming                     phone:     +39 349 2432127