December 2008 Archives by thread

• Messages sorted by: [ subject ] [ author ] [ date ]
• More info on this list...

Starting: Mon Dec 1 14:41:09 CET 2008
Ending: Wed Dec 31 20:59:28 CET 2008
Messages: 54

• [LinuxPPS] pps userland tools fail to build   Thorsten Mühlfelder
• [LinuxPPS] pps userland tools fail to build   Scott Doty on linux-pps list
  • [LinuxPPS] pps userland tools fail to build   Thorsten Mühlfelder
• No subject  
  • [LinuxPPS] 1 Dec 14:11 - pps sysfs: not needed variables removed.   linuxpps: Rodolfo Giometti <>
  • [LinuxPPS] 2 Dec 10:22 - pps ldisc: avoid noisy compilation on 64bits architecture.   linuxpps: Rodolfo Giometti <>
• [LinuxPPS] An extension request.   clemens at dwf.com
• [LinuxPPS] thermostated 14.31818 MHz   Remco den Besten
  • [LinuxPPS] thermostated 14.31818 MHz   Udo van den Heuvel
    • [LinuxPPS] can't get ntp syncing with palisade and atom drivers   Ian Bobbitt
    • [LinuxPPS] can't get ntp syncing with palisade and atom drivers   Hal V. Engel
    • [LinuxPPS] can't get ntp syncing with palisade and atom drivers   Ian Bobbitt
• [LinuxPPS] Fw: linux-next inclusion (was: Re: Btrfs trees for linux-next)   Folkert van Heusden
• [LinuxPPS] low_latency && pps   Udo van den Heuvel
  • [LinuxPPS] low_latency && pps   Thorsten Mühlfelder
    • [LinuxPPS] low_latency && pps   Hal V. Engel
    • [LinuxPPS] low_latency && pps   Udo van den Heuvel
  • [LinuxPPS] low_latency && pps   Thorsten Mühlfelder
• [LinuxPPS] no_hz and pps?   Udo van den Heuvel
  • [LinuxPPS] no_hz and pps?   Hal V. Engel
    • [LinuxPPS] no_hz and pps?   Udo van den Heuvel
      • [LinuxPPS] no_hz and pps?   Udo van den Heuvel
• [LinuxPPS] NTPD crash with nmea patch   Daniel Havey
  • [LinuxPPS] NTPD crash with nmea patch   Udo van den Heuvel
    • [LinuxPPS] NTPD crash with nmea patch   William S. Brasher
• [LinuxPPS] ?   Udo van den Heuvel
• [LinuxPPS] parallel port PPS with FreeBSD   Remco dB
  • [LinuxPPS] parallel port PPS with FreeBSD   clemens at dwf.com
• [LinuxPPS] any hardware folks out there?   Reg Clemens
  • [LinuxPPS] any hardware folks out there?   Remco dB
• [LinuxPPS] any hardware folks out there?   clemens at dwf.com
• [LinuxPPS] 2.6.28...   Udo van den Heuvel
  • [LinuxPPS] 2.6.28...   Udo van den Heuvel
    • [LinuxPPS] 2.6.28...   Udo van den Heuvel
      • [LinuxPPS] 2.6.28...   Udo van den Heuvel
      • [LinuxPPS] 2.6.28...   Udo van den Heuvel
      • [LinuxPPS] 2.6.28...   Udo van den Heuvel
      • [LinuxPPS] 2.6.28...   Udo van den Heuvel
      • [LinuxPPS] 2.6.28...   Ritter, Nicholas
      • [LinuxPPS] 2.6.28...   Ritter, Nicholas
      • [LinuxPPS] 2.6.28...   Udo van den Heuvel
• [LinuxPPS] After a new install, dont see Receiver cards.   clemens at dwf.com
• [LinuxPPS] 100hz versus 250hz kernel   Folkert van Heusden
  • [LinuxPPS] 100hz versus 250hz kernel   Udo van den Heuvel
    • [LinuxPPS] 100hz versus 250hz kernel   Folkert van Heusden
    • [LinuxPPS] 100hz versus 250hz kernel   clemens at dwf.com
      • [LinuxPPS] 100hz versus 250hz kernel   Udo van den Heuvel
      • [LinuxPPS] 100hz versus 250hz kernel   clemens at dwf.com
  • [LinuxPPS] 100hz versus 250hz kernel   Hal V. Engel
• [LinuxPPS] PPS signal quit working.   Daniel Havey
  • [LinuxPPS] PPS signal quit working.   clemens at dwf.com
• [LinuxPPS] Setting the serial port to match the refclock   Paul Simons
  • [LinuxPPS] Setting the serial port to match the refclock   Hal V. Engel
  • [LinuxPPS] Setting the serial port to match the refclock   clemens at dwf.com

Last message date: Wed Dec 31 20:59:28 CET 2008
Archived on: Wed Dec 31 20:29:35 CET 2008

• Messages sorted by: [ subject ] [ author ] [ date ]
• More info on this list...